Article ID : 00030802 / Last Modified : 10/18/2023Print

The lamp on the projector has been replaced, but the Please replace LAMP message is still displaying on the screen.

    After replacing the lamp, the projector will need to be reset to remove the message.  For these projectors, a reset is generally done by pressing the following buttons on the control panel of the projector or on the remote:

    1. Press Reset.
    2. Press the left arrow button.
    3. Press the right arrow button.
    4. Press Enter.

    Note: If using the remote, be sure to point it towards the projector.  If the reset does not work using the remote, try the buttons on the control panel of the projector.

    For further information, refer to the section on replacing the lamp in the manual for your product.

    Manuals are posted on your model support page.