IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
Your wireless speaker doesn't support deleting just one set of pairing information. Initialize your speaker to delete all pairing information.
Select your speaker model, turn it on (except for CAS-1), and then follow the instructions provided to initialize the speaker.
IMPORTANT: Initializing the speaker resets the device to factory default settings, which deletes all network settings and pairing information.
Initialize the CAS-1
Initialize the GTK-XB60
Initialize the LF-S50G
Initialize the LSPX-S1
Initialize the SRS-X1
Initialize the SRS-X9, SRS-X7, SRS-X99, SRS-X88, or SRS-X77
Initialize the SRS-XB3, SRS-XB2, or SRS-HG1
Initialize the SRS-X11
Initialize the SRS-BTD70
Initialize the SRS-ZR7, SRS-ZR5, SRS-XB40, SRS-XB30, SRS-XB20, or SRS-XB10
Note: Depending on the model, it may enter the standby mode after initializing the wireless speaker.