IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
In a scene where the ambient light consists of multiple types of light sources, it is recommended to use the custom white balance in order to accurately reproduce the whiteness.
- In the camera MENU, select Camera Settings.
- Select White Balance.
- Select Custom Setup.
- Hold the camera so that the white area fully covers the AF area located in the center, and then press on the center of the control wheel. The calibrated values Color Temperature and Color Filter are displayed.
- Select a registration number using the Right/Left button. The monitor returns to the recording information display while retaining the memorized custom white balance setting.
NOTE::The message Custom WB Error indicates that the value is higher than the expected range, when the flash is used on a subject with too bright colors in the frame. If you register this value, the indicator turns orange on the recording information display. You can shoot at this point, but it is recommended that you set the white balance again to get a more accurate white balance value.