Article ID : 00025216 / Last Modified : 10/18/2021Print

There is an error message displayed and discs will no longer play.

    IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details.

    If you experience difficulty playing a disc and you receive any of the following error messages, there may be an incorrect setting or there may be a problem with the disc that you are trying to play.

    • NO DISC

    Follow these steps to try to resolve this issue:

    IMPORTANT: Not all CD/DVD players are supplied with the same functions and/or features. To verify model-specific information on any of these steps, refer to the instructions supplied with the product. Manuals are posted on your model support page.

    1. If there is a HOLD switch or function available for the player, make sure that the switch or the function is set OFF.
    2. Verify the disc that you are trying to play is supported by the player.

      NOTE: There are some disc players that do not support VCD or DVD discs, as well as not supporting CD-R or CD-RW discs created by a CD burner. For information regarding disc compatibility with your unit, refer to the operating instructions.

    3. Try playing a couple of different commercially-produced discs.

      NOTE: If more than one commercially-produced disc does not play, verify whether the discs are extended-length discs. Some players are not able to play discs where the recording exceeds the standard 74 minutes. If the recording of the disc is longer than 74 minutes, it is possible that some of the specifications of that disc were compromised and therefore, the CD player will not recognize that disc.

    4. Verify that the disc is inserted correctly, with the playback side of the disc facing down in the disc tray.
    5. If the disc is dirty with fingerprints or smudges, or if the disc is scratched or broken, the player may not recognize the disc, clean the disc using a soft, dry cloth.

      Clean the disc
    6. Reset the player back to the factory-default specifications.
    7. If no discs will play, remove any discs from the player and leave the player powered on with the CD tray opened (if possible) for approximately one hour to resolve the possibility of moisture condensation inside the player.

    The troubleshooting steps listed above should resolve your issue. If you have completed all of the steps and the issue is not resolved, the laser pickup may be dirty.

    IMPORTANT: Sony does not recommend the use of over-the-counter CD/DVD player lens cleaners.

    We recommend bringing the unit in to be cleaned by a factory-trained technician.  Go to Product Repair. 

    Troubleshooting and additional information: